Ip Bridge Domain Commands; Port Ipbpvc Domain Delete Command; Port Ipbpvc Domain Dhcpvlan Enable Command - ZyXEL Communications MSC1024G Series User Manual

Chapter 31 port Commands
The following example deletes the IP bridge PVC on ADSL port 10 with VPI 40, VCI 73.
ras> port ipbpvc show 1-10
pvc
--------------- ------- ---- --- ---------- --------------------------------
--
1-10-40/73
ras> port ipbpvc delete 1-10-40/73
ras> port ipbpvc show 1-10
ras>

31.19 IP Bridge Domain Commands

Use these commands to set up and maintain domains in IP bridges.
A domain represents an ISP. Each domain is defined by (and dominates) the VLAN that are in
it and has its own routing table and ARP table. As a result, two or more VLANs in different
domains can use the same IP subnet, and one network can support multiple ISPs.
VLANs in IP bridges are exclusive. They can be in at most one domain. In addition, VLANs in
IP bridges share the same VLAN space as regular VLANs, so VLANs in IP bridges must have
different VLAN IDs than regular VLANs.

31.19.1 port ipbpvc domain delete Command

Syntax:
port ipbpvc domain delete <domain name>
where
<domain name>
This command deletes the specified domain.
You have to remove the VLANs that are in the domain first.

31.19.2 port ipbpvc domain dhcpvlan enable Command

Syntax:
port ipbpvc domain dhcpvlan enable <domain name> <vid>
where
<domain name>
<vid>
This setting has no effect on DHCP packets that come from VLANs where the system's DHCP
relay settings are active. (See
precedence over the IP bridge DHCP VLAN setting.)
720
type pvid pri ipbpvctype profile
ipb 402 2 llc
The name of the domain.
=
The name of the domain.
=
The ID (<1..4094>) of the VLAN.
=
Chapter 21 on page
DEFVAL
583. The DHCP relay settings take
MSC1000G/1024G/1224G Series User's Guide