ZyXEL Communications MSC1024G Series User Manual page 331

Table 141 VDSL Profile (continued)
LABEL
Interleave
Delay (ms)
Max SNR (0.1
dB)
Min SNR (0.1
dB)
Target SNR
(0.1 dB)
RA Mode
Up-shift Noise
Margin
Down-shift
Noise Margin
Downstream
Max Rate
(kbps)
Min Rate
(Kbps)
Interleave
Delay (ms)
Max SNR (0.1
dB)
Min SNR (0.1
dB)
Target SNR
(0.1 dB)
RA Mode
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Configure this field when you set the Latency Mode field to Interleave. Type the
number of milliseconds of interleave delay to use for upstream transfers. It is
recommended that you configure the same latency delay for both upstream and
downstream.
Type the maximum upstream signal to noise margin (measured in tenths of a
decibel).
Type the minimum upstream signal to noise margin (measured in tenths of a
decibel). Configure the minimum upstream signal to noise margin to be less than
or equal to the maximum upstream signal to noise margin.
Type the target upstream signal to noise margin (measured in tenths of a decibel).
Configure the target upstream signal to noise margin to be greater than or equal to
the minimum upstream signal to noise margin and less than or equal to the
maximum upstream signal to noise margin.
Select how the device adjusts the upstream rate from the configured transmission
rate to the attainable transmission rate depending on the line quality.
Select fix to use a fixed rate you specified in the upstream Max Rate field.
Select startup to use the rate negotiated at link initialization.
Select runtime to use rate adaptation at any time while the connection is up.
The upstream up shift signal to noise margin (measured in tenths of a decibel).
When the channel's signal to noise margin goes above this number, the device
can attempt to use a higher transfer rate. Configure the upstream up shift signal to
noise margin to be greater than or equal to the target upstream signal to noise
margin and less than or equal to the maximum upstream signal to noise margin.
The upstream down shift signal to noise margin (measured in tenths of a decibel).
When the channel's signal to noise margin goes below this number, the device
shifts to a lower transfer rate. Configure the upstream down shift signal to noise
margin to be less than or equal to the target upstream signal to noise margin and
greater than or equal to the minimum upstream signal to noise margin.
The following parameters relate to downstream transmissions.
Type a maximum downstream transfer rate for this port. Configure the maximum
downstream transfer rate to be greater than the maximum upstream transfer rate.
Type the minimum downstream transfer rate for this port. Configure the minimum
downstream transfer rate to be less than the maximum downstream transfer rate.
Configure this field when you set the Latency Mode field to interleave. Type the
number of milliseconds of interleave delay to use for upstream transfers. It is
recommended that you configure the same latency delay for both upstream and
downstream.
Type the maximum downstream signal to noise margin (measured in tenths of a
decibel).
Type the minimum downstream signal to noise margin (measured in tenths of a
decibel). Configure the minimum downstream signal to noise margin to be less
than or equal to the maximum downstream signal to noise margin.
Type the target downstream signal to noise margin (measured in tenths of a
decibel). Configure the target downstream signal to noise margin to be greater
than or equal to the minimum downstream signal to noise margin and less than or
equal to the maximum downstream signal to noise margin.
Select how the device adjusts the downstream rate from the configured
transmission rate to the attainable transmission rate depending on the line quality.
Select fix to use a fixed rate you specified in the downstream Max Rate field.
Select startup to use the rate negotiated at link initialization.
Select runtime to use rate adaptation at any time while the connection is up.
Chapter 13 Profile Screens
331