Radius Screen - ZyXEL Communications MSC1024G Series User Manual

Chapter 5 Access Control List Screens
Figure 60 802.1X PNAC: Port Setup: Slot
The following table describes the labels in this screen.
Table 28 802.1X PNAC: Port Setup: Slot
label
UP
Copy
Port
Enable
Control
Reauthentication
Reauthentication
Period (Sec)
Select

5.13 RADIUS Screen

Click ACL > 802.1X PNAC > RADIUS to display the screen shown next.
122
description
Click UP to go back to the previous screen.
Do the following to copy settings from one port to another port or ports.
1. Select the Select radio button of the port from which you want to copy settings
2. Click Copy.
3. Select to which line card you want to copy the settings.
4. Select to which ports on the line card you want to copy the settings. Use Select
All to select every port. Use Select None to clear all of the check boxes.
5. Click Apply to paste the settings.
This field displays the number of the DSL port.
This field displays whether IEEE 802.1x is turned on or not (V for enabled, - for
disabled).
This field displays the IEEE 802.1x port authentication option for a subscriber port.
This field displays whether the IEEE 802.1x re-authentication option is turned on
or not (V for enabled, - for disabled).
This field displays the IEEE 802.1x re-authentication period.
Select the radio button of the port from which you want to copy settings.
MSC1000G/1024G/1224G Series User's Guide