Show Lineinfo Command - ZyXEL Communications MSC1024G Series User Manual

This command displays the (run-time) routing table(s) for the selected domain or range of IP
addresses. This table includes all the entries, whether added automatically by the system or
provided manually.
An example is shown next.
ras> show ipbpvc route
domain
------------------------------- ------------------ --------------- ---- -- ---
ISP1
ISP1
ISP1
ISP1
example
The type field indicates whether this entry is used for upstream traffic (U, or uplink
interface) or downstream traffic (D, or downlink interface). By default, all entries are for
downstream traffic, unless the Edge Router IP is configured in the edge router commands
(see Section 31.20 on page
The other output values correspond to the input values of other IP bridge routing table
commands.

33.3.17 show lineinfo Command

Syntax:
show lineinfo <slot-port>
This command shows the line operating values of a port.
33.3.17.1 xDSL Line Card
The following example displays the line operating values for port 5 on the ADSL line card in
slot 7.
ras> show lineinfo 7-5
slot-port=1-1, DSL line info
link
service type
coding mode
us interleave delay = 18 ms
ds interleave delay = 6 ms
us inp
ds inp
us output power
ds output power
country code
provider code
MSC1000G/1024G/1224G Series User's Guide
ip/mask
0.0.0.0/0
123.23.19.249/32
123.23.19.254/32
192.169.1.0/24
192.168.1.200/32
722).
= link_up
= adsl2plus_mode
= Concatenated (trellis and RS) coding
= 2.1 DMT symbol(s)
= 0.5 DMT symbol(s)
= 9.6 dBm
= 13.7 dBm
= 0000
= 5443544e("TCTN")
Chapter 33 show Commands
nexthop mtrc pr type
123.23.19.254 15
- -
- -
123.23.19.249 5
- -
0 U
- U
- U
0 U
- U
843