ZyXEL Communications MSC1024G Series User Manual page 365

Table 161 Profile > VoIP SIP
LABEL
Port
Proxy Server IP / Domain
Name
Port
URI Type
802.1p Priority
DSCP
Keep Alive
Session Expiration Time
PRACK
Apply
New
Cancel
The bottom part of the screen lists the configured profiles.
Index
Name
Sip Server IP / Domain
Name
Modify
Delete
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Enter the SIP registrar server's listening port number, if the VoIP service
provider gave you one. Otherwise, enter the same port number you
entered in the SIP IP / Domain Name Port field.
Enter the IP address or domain name of the SIP server or outbound proxy
SIP server (if supplied by your VoIP service provider).
The system uses this address to communicate with the SIP server.
Enter the SIP outbound server's listening port number, if the service
provider gave you one. Otherwise, enter the same port number you
entered in the SIP IP / Domain Name Port field.
Use this to configure how Universal Resource Indicators (URIs) are sent.
Select SIP where SIP messages are sent to a domain name or IP
address.
Select TEL where SIP messages are sent to addresses represented
as telephone numbers.
Set the IEEE 802.1p priority value for SIP and RTP traffic using this SIP
profile.
Set the DiffServ Code Point (DSCP) value for SIP and RTP traffic using
this SIP profile.
Turn SIP session keepalive on or off. When this is on, the SIP UA
periodically sends SIP session refresh requests.
Enter the minimum number of seconds after which the system tears down
the session (if no successful session refresh has occurred).
Sets whether the system sends provisional acknowledgment messages
(ON), or does not send them (OFF).
Click Apply to save the changes in this screen to the system's volatile
memory. The system loses these changes if it is turned off or loses power,
so use the Config Save on the navigation panel and then the Save button
to save your changes to the non-volatile memory when you are done
configuring.
While you are modifying a profile, you can click New to start configuring a
fresh profile without saving your changes.
Click Cancel to start configuring the screen again.
This is the port profile index number.
These are the names of individual profiles. The DEFVAL profile always
exists, and is assigned to all ports by default.
This displays the IP address or domain name of your VoIP provider's SIP
server.
Select a profile's Select radio button and click Modify to edit the profile.
Select a profile's Select radio button and click Delete to remove the
profile.
Chapter 13 Profile Screens
365