ZyXEL Communications MSC1024G Series User Manual page 689

Table 325 port Commands (continued)
COMMAND
power
psd
set
uscarrier
MSC1000G/1024G/1224G Series User's Guide
param <slot-port>
[l0time <l0time>]
[l2time <l2time>]
[l2pcb <l2atpr>
<l2atprt>] [l2rate
<l2minrate>
<l2maxrate>
<l2threshold>]
<slot-port>
fix|power|rate
<max_us_tx>
<max_ds_tx>
<max_rx>
maximum [<slot-
port> <us-psd> <ds-
psd>]
<slot-port>
<profile> <mode>
<slot-port> <m0>
<m1>
Chapter 31 port Commands
DESCRIPTION
Sets the L0 (full power) and L2 (low power)
power mode transition settings.
l0time : Time (10~ 65535 seconds) to
stay in L0 mode.
l2time : Time (10~65535 seconds) to
wait before performing another power trims
in L2 mode.
l2atpr : Maximum aggregated power
reduction (APTR) per trim in dB
(0~ l2atprt ).
l2atprt : Maximum total aggregate
power reduction in dB (0~15).
l2minrate : Minimum rate in L2
(32~4096).
l2maxrate : Maximum rate in L2
(minimum L2 rate ~ maximum upstream
rate in kbps).
: Line rate threshold to
l2threshold
stay in L2 mode. When the rate is not
within the threshold, the port switches to L0
mode immediately.
Specifies the maximum allowed
transmission power and maximum
aggregate received power.
fix|power|rate : PSD and power
adaptivity:
fix: fixed mode
priority to power
:
power
rate: priority to rate
max_us_tx : maximum upstream
transmission power (-130~200 in 0.1
dBm).
max_ds_tx : maximum downstream
transmit power (-50~200 in 0.1 dBm).
max_rx : maximum aggregate receive
power at atu-c (-255~255 in 0.1 dBm).
Sets/displays maximum upstream/
downstream nominal PSD values. This is
for testing purposes.
us-psd: Upstream PSD (-400 ~ 40 in
0.1dBm/Hz).
ds-psd: Downstream PSD (-400 ~ 40 in
0.1dBm/Hz).
Sets ADSL port(s) to use a profile created
by the profile adsl set
:
mode
for Annex A, choose gdmt, t1413,
glite, auto, adsl2, or adsl2+.
for Annex B, choose gdmt, etsi,
auto, adsl2, or adsl2+.
Disables upstream carrier tones from 0 to
63.
: carrier tones, 0~ffffffff, '1' disables
m0,m1
the corresponding tone.
P
M
M
M
M
command.
M
689