Ip Bridge Interface Commands; Port Ipbpvc Interface Delete Command - ZyXEL Communications MSC1024G Series User Manual

Chapter 31 port Commands
An example is shown next.
ras> port ipbpvc edgerouter show all
domain
------------------------------- ------------------ --------
ISP1
ISP1
example
The output values correspond to the input values of other IP bridge edge router commands.

31.21 IP Bridge Interface Commands

Use these commands to set up and maintain forwarding information for downstream traffic.
Downlink interfaces provide forwarding information for downstream traffic. The system
learns some of this information by snooping DHCP packets. For static IP addresses, you
should provide this information manually. In this case, specify the VLAN ID and, optionally,
the PVC for a range of IP addresses. The system uses the VLAN ID to identify the domain the
downlink interface is in. Downlink interfaces in the same domain cannot have overlapping IP
addresses.

31.21.1 port ipbpvc interface delete Command

Syntax:
port ipbpvc interface delete <ip/mask> <vid>
where
<ip/mask>
<vid>
This command deletes the specified downlink interface. You can only remove downlink
interfaces that were added manually.
The following example removes the downlink interface for 192.168.1.200/24 in VLAN 402.
ras> port ipbpvc interface show 402
ip/mask
------------------ ---- ---- ---- --- ----
192.168.1.200/24
ras> port interface delete 192.168.1.200/24 402
ras> port ipbpvc interface show 402
ras>
31.21.2 port ipbpvc interface set Command
Syntax:
port ipbpvc interface set <ip/mask> <vid> [<slot-port-vpi/vci>]
724
ip/mask
123.23.19.249/24
123.23.19.254/24
192.168.1.200/24
Downlink interface's IP address, in dotted decimal notation and number
=
of bits <1..32> in the subnet mask.
The ID (<1..4094>) of the VLAN.
=
vid slot port vpi vci
402 - -
vid
102
101
402
- -
MSC1000G/1024G/1224G Series User's Guide