Diagnostic Commands Summary - ZyXEL Communications MSC1024G Series User Manual

26.3
diagnostic
The following table lists the
administrator privilege level needed to use the command (H for high, M for middle or L for
low).
Table 316 diagnostic Commands
COMMAND
diagnostic cfm
ldm
MSC1000G/1024G/1224G Series User's Guide
Commands Summary
diagnostic
loopba <md-name> <ma-
ck name> <ep-id>
<remote-ep-
id>|<mac>
linktr set <md-name> <ma-
ace name> <ep-id>
<remote-ep-
id>|<mac> <ttl>
show <md-name>
<ma-name> <ep-id>
[<ltm-id> [ltr-
index]]
show <slot-port>
result|hlin|hlog|q
ln|snr
test <slot-port>
Chapter 26 diagnostic Commands
commands. The P column on the right indicates the
DESCRIPTION
Specifies the MD name, MA name, MEP
ID, destination (MEP ID or MAC address)
to perform a loopback test.
This enables the MEP port (with the
specified MEP ID) in a specified CFM
domain to send the LBMs (Loop Back
Messages) to a specified remote end
point.
Specifies the MD name, MA name, MEP
ID, destination (MEP ID or MAC address)
to perform a link trace test.
This enables the MEP port (with the
specified MEP ID) in a specified CFM
domain to send the LTMs (Link Trace
Messages) to a specified remote end
point.
ttl: This is Time-To-Live value (1~63
seconds). Sets this to stop a test once it
exceeds the time duration without
receiving any response.
Displays a link trace test report. You can
see detailed test report by specifying the
ltm-id or ltm-id ltr-index.
ltm-id: This is the index number of the
link trace messages sent in a link trace
test.
ltr-index: This is the index number of
the link trace responses received in the
Device in a link trace test.
A Loop Diagnostic Mode test provides
details about the condition of an ADSL
line. This feature is applicable for ALC
line cards only.
Displays the most recent loop diagnostic
mode test results for the specified
subscriber port.
Sets the specified subscriber port to loop
diagnostic mode and displays the results.
P
M
M
L
M
M
633