Chapter 11 Subscriber Port Setup Screens
Figure 162 IPB ARP Proxy
The following table describes the labels in this screen.
Table 107 IPB ARP Proxy
LABEL
Aging Time
Apply
Cancel
Type
Domain
IP/Mask
Flush
11.16 IPB Domain Screen
Use this screen to set up and maintain domains in an IP bridge. A domain represents an ISP.
Each domain is defined by (and dominates) the VLAN that are in it and has its own routing
table and ARP table.
To open this screen, click Port > IP Bridge > Domain.
264
DESCRIPTION
Enter a number of seconds (10~10000) to set how long the MSC keeps ARP
table entries for IP bridge domains.
Click Apply to save your changes to the MSC's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Select whether you want to clear edge router, interface (or all) ARP table
entries.
Select the domain whose ARP table you want to clear.
Select the IP address and subnet mask bit number whose ARP table you want
to clear.
Click Flush to remove entries from the ARP table.
MSC1000G/1024G/1224G Series User's Guide