Chapter 31 port Commands
31.3 port Commands
Use the
port
31.4 port adsl Commands
Use the
port adsl
31.4.1 port adsl alarmprof Command
Syntax:
port adsl alarmprof <slot-port> <alarmprofile>
where
<alarmprofile>
This command applies (maps) an ADSL alarm profile to the subscriber port(s).
The following example sets ADSL port 5 on the line card in slot 7 to use the SESalarm alarm
profile.
ras> port adsl alarmprofile 7-5 SESalarm
31.4.2 port adsl annexl disable Command
Syntax:
port adsl annexl disable <slot-port>
This command turns off the Annex L reach extended feature on the specified ADSL2 port(s).
The following example turns off the Annex L feature for port 5 on the line card in slot 75.
ras> port adsl annexl disable 5-7
31.4.3 port adsl annexl enable Command
Syntax:
port adsl annexl enable <slot-port> [narrow]
where
[narrow]
This command turns on the Annex L reach extended feature on the specified ADSL2 port(s).
Annex L can be used with Annex A (ADSL over POTS), not Annex B (ADSL over ISDN).
700
commands to configure the line card ports.
commands to configure the subscriber ADSL ports.
=
The name of an ADSL alarm profile.
The "narrow" PSD (Power Spectral Density) mode. The narrow mode
=
supports longer loop lengths but has lower transmission speeds.
The "wide" PSD mode is used if you do not enter "narrow". The wide mode
supports higher transmission speeds but requires shorter loop lengths.
MSC1000G/1024G/1224G Series User's Guide