Mvlan Group Setup Screen - ZyXEL Communications MSC1024G Series User Manual

Managment switch card

Hide thumbs Also See for MSC1024G Series:

Table of Contents

The following table describes the labels in this screen.

Table 74 MVLAN Port Setting

10.8 MVLAN Group Setup Screen

Click Multicast > MVLAN in the navigation panel to display the MVLAN configuration

screen. Click a MVLAN's VID to open the following screen where you can edit the multicast

group that the MVLAN uses.

Figure 122 MVLAN Group Setup

The following table describes the labels in this screen.

Table 75 MVLAN Group Setup

MSC1000G/1024G/1224G Series User's Guide

The numbers represent the individual ports on the card.

Use the F, -, and X radio buttons to set each port's membership in the MVLAN.

Select F to make the port a permanent member of the MVLAN.

Select - to make the port a normal member and allow it to join the MVLAN

dynamically.

Select X to set the port to "forbidden" meaning it is always blocked from joining the

Use the All Fix, All Normal or All Forbidden button if you want to set all of the

card's ports to the same membership status for this MVLAN.

Click Apply to save the changes in this screen to the system's volatile memory. The

system loses these changes if it is turned off or loses power, so use the Config Save

on the navigation panel and then the Save button to save your changes to the non-

volatile memory when you are done configuring.

Click Cancel to close the screen without saving your changes.

This is the ID number of the MVLAN.

Select the multicast group number (1 -16).

Enter a multicast IP address as the beginning of the multicast IP address range.

Enter a multicast IP address as the finish of the multicast IP address range.

Chapter 10 Multicast Screens

Msc1224g series Msc1000g series