Vlan Port Setting Screen - ZyXEL Communications MSC1024G Series User Manual

Table 283 VLAN Setup (continued)
LABEL
Registration
Tag
Apply
New
Cancel
Show VID From Type a range of VLAN IDs that you want to view and click Apply to display them in
Index
Name
VID
Enable
ENET Ports
Page X of X
Previous/Next
Page
Modify
Delete

17.7 VLAN Port Setting Screen

Click VLAN > Port Setting in the navigation panel to display the screen shown next. You can
select a DSL line card to view the VLAN settings on its ports.
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Select Normal for the port to dynamically join this VLAN group using GVRP.
Select Fix for the port to be a permanent member of this VLAN group.
Select Forbidden if you want to prohibit the port from joining this VLAN group.
You cannot change a port from the fixed state to another state if the port's PVID is set
to this VLAN. The VLAN must have at least one port set to the fixed status if the
VLAN is the CPU (management) VLAN.
Select this check box if you want to tag all frames transmitted though a port with this
VLAN group ID.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click New to start configuring the screen again.
Click Cancel to start configuring the screen again.
the table below.
This field displays the number of the VLAN entry in this list.
This field displays the descriptive name for this VLAN group.
This field displays the ID number of the VLAN group. Click the number to edit the
VLAN settings.
This field indicates whether the VLAN settings are enabled (V) or disabled (-).
This column displays the VLAN tagging settings of the MSC' Gigabit Ethernet
interfaces.
ENET port 1 and 2 are subtending ports 1 and 2.
ENET port 3 and 4 are uplink ports 1 and 2.
ENET ports 5~8 do not apply (and nothing displays).
T displays if the system is to tag all frames transmitted though the port with this
VLAN group ID.
U displays if the system is not to tag all frames transmitted though the port with this
VLAN group ID.
An X indicates that the port is forbidden (blocked) from joining the static multicast
group.
An - indicates that the port is a normal member and can join the VLAN dynamically.
This identifies which page of information is displayed and the total number of pages
of information.
Click one of these buttons to show the preceding/following screen if the information
cannot be displayed in one screen.
Select a VLAN's Select radio button and click Modify to edit the VLAN.
Select a VLAN's Select radio button and click Delete to remove the VLAN.You
cannot delete the CPU (management) VLAN.
Chapter 17 VLAN Screens
535