37.2 voip arp Commands
Use these commands to control ARP (Address Resolution Protocol) on the VoIP line cards.
37.2.1 voip arp flush Command
Syntax:
voip arp flush <slot>
This command removes all ARP (Address Resolution Protocol) table entries stored in the
specified VoIP line card.
The following example deletes all ARP table entries from slot 4.
ras> voip arp flush 4
37.2.2 voip arp show Command
Syntax:
voip arp show <slot>
This command displays all ARP (Address Resolution Protocol) table entries stored in the
specified VoIP line card.
The following example displays all ARP table entries in slot 4.
ras> voip arp show 4
slot ip mac timer
---- --------------- ----------------- -----
3 192.168.2.2 00:0f:ea:7b:cb:a1 280
3 192.168.2.4 00:0f:ea:79:01:c3 30
3 192.168.2.11 00:08:02:da:6b:97 270
3 192.168.2.20 00:0f:ea:79:01:d3 270
3 192.168.2.52 00:05:5d:96:ea:78 40
3 192.168.2.136 00:13:49:24:b0:78 300
3 192.168.2.159 00:13:49:24:b0:77 300
37.3 voip countrycode Commands
Use these commands to set the country of operation, or the country with the same
configuration as the country of operation. The following lists the variables affected by the
selected country code.
• AC impedance
• PCM companding law
• Cadence ring
• Flash time
• Pulse dial interval
• Pay-signal type
MSC1000G/1024G/1224G Series User's Guide
Chapter 37 voip Commands
941