Upstream Broadcast Control Screen - ZyXEL Communications MSC1024G Series User Manual

Figure 61 802.1X PNAC: RADIUS
The following table describes the labels in this screen.
Table 29 802.1X PNAC: RADIUS
LABEL
Enable
Radius Server
1/2
IP address
UDP Port
Shared Secret
Apply
Cancel

5.14 Upstream Broadcast Control Screen

Upstream broadcast allows you to define the maximum bandwidth for upstream broadcast
traffic allowed in each VDSL subscriber line. This is useful to reduce the incoming broadcast
packets and system load.
Click ACL > Upstream Broadcast to display the screen shown next.
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Select this check box to have the switch use an external RADIUS server to
authenticate users.
Enter the IP address of the external RADIUS server in dotted decimal notation.
The default port of the RADIUS server for authentication is 1812. You need not
change this value unless your network administrator instructs you to do so.
Specify a password (up to 31 alphanumeric characters) as the key to be shared
between the external RADIUS server and the system. This key is not sent over the
network. This key must be the same on the external RADIUS server and the switch.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config
Save on the navigation panel and then the Save button to save your changes to the
non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Chapter 5 Access Control List Screens
123