Voip H248 Opmode Command; Voip H248 Priority Command; Voip H248 Show Command - ZyXEL Communications MSC1024G Series User Manual

The following example sets a media VOP in slot 3 to use the VOP card at IP address
192.168.3.174 as the primary signaling card and no secondary signaling card.
ras> voip h248 master 3 192.168.3.174 0.0.0.0

37.4.10 voip h248 opmode command

Syntax:
voip h248 opmode <slot> mc|sc
where
mc
sc
Use this command to set a VOP card as a media card or a signaling card. A signaling card can
also function as a media card.
The following example sets a VOP in slot 3 to be a signaling card.
ras> voip h248 opmode 3 sc

37.4.11 voip h248 priority command

Syntax:
voip h248 priority <slot> <pbit> <dscp>
where
pbit
dscp
Use this command to set the IEEE 802.1p priority (0~7) and DSCP code point (0~63) to use
for this VoIP card's H.248 signaling packets.
The following example sets the VOP card in slot 3's traffic to have IEEE 802.1p priority 7 and
DSCP code point 63.
ras> voip h248 priority 3 7 63

37.4.12 voip h248 show command

Syntax:
voip h248 show [<slot>]
Use this command to see the H.248 VoIP cards and their operational modes. Specify a H.248
VoIP card's slot number to show it's general H.248 settings.
MSC1000G/1024G/1224G Series User's Guide
Function as a media card.
Function as a signaling card.
The 802.1p priority bit for H.248 and RTP packets (0 ~ 7).
The DSCP bit for H.248 and RTP packets (0 ~ 63).
Chapter 37 voip Commands
947