The Advanced H248 Port Setup Screen - ZyXEL Communications MSC1024G Series User Manual

The following table describes the labels in this screen.
Table 120 Port > VoIP H248 Setup > H248 Port Setup Line Card Screen
LABEL
UP
Copy
Apply
Cancel
Port
Enable
Termination
DSP Profile
Select

11.27 The Advanced H248 Port Setup Screen

Use this screen to configure the VoIP settings of a port on your H.248 VoIP line card. Click a
port number in the Port H248 Setup Line Card screen (see
following screen displays.
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Click this to return to the Port > VoIP H248 screen.
Use this to assign the selected port's settings to other ports.
1. Click Copy. The following pop-up screen displays.
Figure 181 Copy Port Settings
2. Select the required slot from the drop-down list.
3. Select the port(s) to which you want to copy the settings. Use Select All
to select every port. Use Select None to clear all of the check boxes.
4. Click Apply to copy the settings, or click Cancel to close the window
without saving any changes.
Click this to save your changes to the MSC's volatile memory. The MSC
loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Click this to begin configuring the fields again.
These are the numbers of the line card's ports.
Click a port number to display the Advanced H248 Port Setup screen (see
Section 11.27 on page 289).
Select a check box in this column to activate a port. Select the check box at
the top of the column to activate all of the line card's ports.
Enter the name for this port's H.248 Termination. By default, the port's
Termination name is "termX", where X is the port number. Enter up to 31
alphanumeric characters. Spaces are not allowed.
Select the digital signal processing profile the port is to use. If you have not
configured any profiles, only the default profile DEFVAL can be selected.
Configure DSP profiles in the Profile > VoIP DSP screen.
Use this column to choose a port from which you want to copy settings.
Chapter 11 Subscriber Port Setup Screens
Section 11.23 on page 282). The
289