Table 347 switch Commands (continued)
COMMAND
34.4 switch bandwidth Commands
Use the
switch bandwidth
34.4.1 switch bandwidth disable Command
Syntax:
switch bandwidth enable <giga-port>
where
<giga-port>
This command turns on bandwidth control on the specified Gigabit Ethernet interface (or all of
them).
This example turns off bandwidth control for the uplink 1 port.
ras>
switch bandwidth disable up1
34.4.2 switch bandwidth enable Command
Syntax:
switch bandwidth enable <giga-port>
where
<giga-port>
This command turns on bandwidth control on the specified port(s).
This example turns on bandwidth control for the subtending 2 port.
ras>
switch bandwidth enable sub2
MSC1000G/1024G/1224G Series User's Guide
set
<vid> <priority>
show
[vid]
commands to configure bandwidth control.
=
This represents Gigabit Ethernet uplink ports, subtending ports or all ports.
Use
sub1|sub2|up1|up2|all i
sub|up|all
=
This represents Gigabit Ethernet uplink ports, subtending ports or all ports.
Use
sub1|sub2|up1|up2|all i
t
sub|tup|all
DESCRIPTION
Has the system assign the specified
priority to traffic with the specified VLAN
ID.
Displays the current setting for VLAN-
based priority or the VLAN-based priority
setting for a specific VLAN ID.
f trunking is not enabled. Use
if trunking is enabled.
f trunking is not enabled. Use
if trunking is enabled.
Chapter 34 switch Commands
P
M
L
873