Chapter 34 switch Commands
This command turns off the system's subscriber isolation setting. An example is shown next.
ras> switch isolation disable
port isolation :enabled
ras>
34.8.4 switch isolation vlan delete Command
Syntax:
switch isolation vlan delete <vid>
where
<vid>
This command turns off per-VLAN isolation for the specified VLAN.
Per-VLAN isolation only works when the regular switch isolation feature is
disabled (see
The following example turns off per-VLAN isolation for VLAN 5.
ras> switch isolation vlan delete 5
ras> switch isolation show
port isolation :disabled
isolated vlan list:
----
938
34.8.5 switch isolation vlan set Command
Syntax:
switch isolation vlan set <vid>
where
<vid>
This command turns on per-VLAN isolation for the specified VLAN.
Per-VLAN isolation only works when the regular switch isolation feature is
disabled (see
888
The VLAN ID [1 – 4094].
=
Section 34.8.3 on page
The VLAN ID [1 – 4094].
=
Section 34.8.3 on page
887).
887).
MSC1000G/1024G/1224G Series User's Guide