The following table describes the labels in this screen.
Table 61 CFM Loopback
LABEL
MD
MA
MEPID
Target
Test
8.8 CFM Linktrace Screen
Click Diagnostic > CFM Linktrace in the navigation panel to display this screen. Use this
screen to perform a link trace connectivity test on a link.
Figure 98 Diagnostic > CFM Linktrace
The following table describes the labels in this screen.
Table 62 Diagnostic > CFM Linktrace
LABEL
MD
MA
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Select an MD name.
If the drop-down list is empty, create an MD in the Switch > CFM screen.
Select an MA name under the selected MD.
If the drop-down list is empty, create an MA in the Switch > CFM > CFM maintenance
association screen.
Select an MEP ID to specify which MEP port on the device initiates the test.
If the drop-down list is empty, create an MA in the Switch > CFM > CFM maintenance
association > CFM endpoint screen.
Specify the destination of the link you are checking. You can select MEPID and enter a
remote MEP's ID or select MAC and enter a remote MEP port's MAC address.
Click this to start the loopback connectivity test.
DESCRIPTION
Select an MD name.
If the drop-down list is empty, create an MD in the Switch > CFM screen.
Select an MA name under the selected MD.
If the drop-down list is empty, create an MA in the Switch > CFM > CFM maintenance
association screen.
Chapter 8 Diagnostic Screens
183