ZyXEL Communications MSC1024G Series User Manual page 146

Chapter 6 Alarm Screens
The following table describes the labels in this screen.
Table 44 Alarm Port Setup
LABEL
sub1
sub2
up1
up2
Management
Apply
Slot
Port
Load
Severity
Apply
Cancel
Copy
ID
146
DESCRIPTION
Select the severity level from info, minor, major and critical for the alarms to
record on the specified port of the MSC.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config
Save on the navigation panel and then the Save button to save your changes to the
non-volatile memory when you are done configuring.
Use the drop-down list boxes to select an DSL port on a line card for which you wish
to configure the severity level.
Click Load to refresh the whole screen.
Select the minimum severity level of alarms (info, minor, major or critical) that the
system records on the port.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config
Save on the navigation panel and then the Save button to save your changes to the
non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Do the following to copy settings from one port to another port or ports.
1. Select the Select radio button of the port from which you want to copy settings
2. Click Copy.
3. Select to which line card you want to copy the settings.
4. Select to which ports on the line card you want to copy the settings. Use Select
All to select every port. Use Select None to clear all of the check boxes.
5. Click Apply to paste the settings.
This is the slot number of a line card. Click the index number of an active line card to
display the Alarm Port Setup Slot screen where you can view and copy settings
from one port to another port or ports on the selected line card.
MSC1000G/1024G/1224G Series User's Guide