Port Vdsl Rfiband Command; Port Vdsl Rficustom Commands - ZyXEL Communications MSC1024G Series User Manual

where
<etype>
<vid>
<priority>
This command sets a private VLAN setting on a specified DSL port. The following example
sets up a private VLAN with an IPv6 Ethernet type, an ID of 1 and a priority of 1 on traffic on
port 5 on the VDSL card in slot 4.
ras> port vdsl pvlan 4-5 86DD 1 1

31.34.13 port vdsl rfiband Command

Syntax:
port vdsl rfiband <slot-port> <disable|ansi|etsi|custom>
where
<disable|ansi|etsi
|custom>
Use this command to specify an RFI mode or disable this feature.

31.34.14 port vdsl rficustom Commands

Syntax:
port vdsl rficustom disable <index>
port vdsl rficustom enable <index>
port vdsl rficustom set <index> <start_freq> <stop_freq>
port vdsl rficustom show
where
<index>
<start_freq>
<stop_freq>
Use these commands to configure or display the settings of a custom RFI entry.
An example is show below:
• Creates a custom RFI entry with the frequency between 3500 and 3800 kHz.
• Activate the settings.
MSC1000G/1024G/1224G Series User's Guide
= The ether type in hexadecimal.
The VLAN ID from 1~4094
=
= The priority setting from 0~7
Enter
= ansi
Enter disable
Enter custom
the
port vdsl rficustom
This is index number (1-8) of the custom RFI entry.
=
= This is the start of the frequency range in kHz (0~2147483647).
Note:
<start_freq>
= This is the end of the frequency range in kHz.
Chapter 31 port Commands
or to use the pre-defined RFI band.
etsi
to deactivate this feature.
to use the RFI band settings configured using
command.
cannot be bigger than .
<stop_freq>
749