Ipqos Profile Screen - ZyXEL Communications MSC1024G Series User Manual

Figure 254 Config Save Screen

13.23.4 IPQoS Profile Screen

Click Profile > IPQoS in the navigation panel to open the following screen. Use this screen to
configure QoS (Quality of Service) profile setting for each traffic queue.
Use the top part of the screen to add or edit IPQoS profiles. The bottom of the screen lists the
configured IPQoS profiles. See
The IES classifies traffic into queues based on IEEE 802.1P tags,
After you configure the IPQoS profiles here, you apply them to VDSL ports or ADSL PVCs.
Figure 255 IPQoS Profile
The following table describes the fields in this screen.
Table 168 IPQoS Profile
LABEL
Name
Number of
Queues
Queue Id
PIR
MSC1000G/1024G/1224G Series User's Guide
Section 15.4 on page 474
DESCRIPTION
Type a name to identify the IPQoS profile (you cannot change the name of the DEFVAL
profile). You can use up to 31 English keyboard characters; spaces are not allowed.
Select the number of queues used to classify traffic. You can select 1, 2, 4 or 8 queues in
an IPQoS profile depending on the number of applications you want to classify.
Note: It's highly recommended to use 8 queues for traffic classification.
This is the index number of queues listed in the following table according to what you
selected in the Number of Queues field.
PIR is Peak Information Rate. Enter the maximum data rate (128~32768 kbps) allowed to
flow through this device at peak hour. You must enter the number which is a multiple of
64. See Section 13.23 on page 373
Chapter 13 Profile Screens
for more on traffic queuing.
for more information.
387