Alarm Show Command - ZyXEL Communications MSC1024G Series User Manual

where
<fac>
<target>
This command displays port alarm severity level thresholds. The system reports an alarm on a
port if the alarm has a severity equal to or higher than the port's threshold.
The following example displays the port alarm thresholds for the ports on the line card in slot
4. "ifindex" identifies the interface.
ras> alarm port show 4
ifindex
----------
4- 1
4- 2
4- 3
-------------------------- [snip] --------------------------
4-44
4-45
4-46
4-47
4-48

22.3.8 alarm show Command

Syntax:
alarm show [<severity>|all] [<alarm>|all] [<condition>|all] [<sdate>|all]
[<edate>|all] [for|rev] [detail]
where
[detail]
This command displays the current alarms by severity, alarm category or alarm condition.
MSC1000G/1024G/1224G Series User's Guide
= The log facility ( local1~local7
messages to different files in the syslog server. See your syslog program's
documentation for details.
= snmp|syslog|all|none
is to send (SNMP, syslog or all).
category.
severity
-----------
minor
minor
minor
minor
minor
minor
minor
minor
= Display in depth alarm information.
Chapter 22 alarm Commands
) that has the device log the syslog
The type of alarm messages that the device
none disables alarm reports on this alarm
617