ZyXEL Communications MSC1024G Series User Manual page 78

Chapter 4 Tutorials
It is highly recommended that you use the sys reboot <seconds>
command before using any settings or commands that may lock you out from
managing the device. Use the sys reboot cancel command to cancel the
scheduled reboot when you are sure you have the correct configuration.
Otherwise, the device will restart and resume using the settings last saved
before using the sys reboot command.
By default, you can access the management VLAN from all of the IES's in-
band ports since they are all in the management VLAN. If you need more
security, please see
the management VLAN.
Figure 22 IP Setup
4 Use the following steps to quickly test the connection between the Device and VDSL
subscribers.
First make sure you correctly install a VLC line card. See the Quick Start Guide for
installing a line card. Connect one VDSL CPE device's (for example, P870H-51) DSL
port to one VLC card's port (in this example, slot 7 and port 1). Connect a computer (A)
to the CPE's LAN port and connect another computer (B) to an MSC's Ethernet port (for
example, port 2).
Figure 23 Subscriber Connection Test
A
5 Enable the VDSL port in the Port > VDSL screen on the Device.
78
Section 28.2.9.1 on page 662
CPE
Ping
for an example of changing
CO
B
MSC1000G/1024G/1224G Series User's Guide