Chapter 34 switch Commands
Table 347 switch Commands (continued)
COMMAND
bcastctrl
cfm
868
show
show
threshold <giga-port> <bc-
limit> <mc-limit>
<uu-limit>
disable
enable
lbr
disable <giga-
port>|<slot-port>
enable <giga-
port>|<slot-port>
show
ma
delete <md-name>
<ma-name>
meplist delete
<md-name> <ma-
name> <ep-id>
meplist set <md-
name> <ma-name>
<mep-id>
set <md-name> <ma-
name> <primary-
vlan> [<cci-
interval>]
vlan delete <md-
name> <ma-name>
<vlan-id>
vlan set <md-name>
<ma-name> <vlan-
id>
md
delete <md-name>
set <md-name>
<level>
mep
delete <md-name>
<ma-name> <mep-id>
DESCRIPTION
Displays the bandwidth control settings.
Displays broadcast and multicast storm
control settings.
Sets the limitations of broadcast, multicast
and unknown unicast packets, in packets
per second for each trunk port (0~262143,
-1 means no limit).
:
broadcast packet limit
bc-limit
:
multicast packet limit
mc-limit
:
unknown unicast packet limit
uu-limit
Disables Connectivity Fault Management
(CFM).
Enables CFM.
Disables loopback testing on the specified
port on a line card.
Enables loopback testing on the specified
port on a line card.
Displays loopback testing settings.
Deletes a maintenance association (MA).
Deletes a list of MA end points (MEP).
Sets a list of MEP.
Set an MA.
primary-vlan: primary served VLAN of
this association.
cci-interval: continuity check
message initiation interval, range is 4~7.
4: 1 s
5: 10 s
6: 1 min
7: 10 min
Deletes a VLAN from an MA.
Associates a VLAN with an MA.
Deletes an MD.
Sets an MD and it's level.
level: maintenance domain level, 0~7
Deletes a MEP.
MSC1000G/1024G/1224G Series User's Guide
P
L
L
M
M
M
M
M
L
M
M
M
M
M
M
M
M
M