ZyXEL Communications MSC1024G Series User Manual page 265

Figure 163 IPB Domain
The following table describes the labels in this screen.
Table 108 IPB Domain
LABEL
Name
DHCP VLAN
Apply
New
Cancel
Add VLAN
Apply
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Enter the name of the domain you want to create. You can use 1-31 printable
English keyboard characters, except for right angle brackets (>). Spaces are not
allowed.
Select the VLAN where the domain's DHCP server is located. If you select a
specific VLAN, the MSC forwards subscribers' DHCP packets to the selected
VLAN and changes the source MAC address to the MSC's MAC address.
Select Disabled if there is no DHCP server for the domain, in which case the
MSC does not change the source MAC address in DHCP packets.
This setting has no effect on DHCP packets that come from VLANs where the
MSC's DHCP relay settings are active. See
DHCP relay settings take precedence over the IP bridge DHCP VLAN setting.
The MSC also still adds whatever Option 82 information is specified for the
VLAN in the DHCP relay settings.
Click Apply to create the domain. It is then displayed in the summary table at
the bottom of the screen.
Clicking Apply saves your changes to the MSC's volatile memory. The MSC
loses these changes if it is turned off or loses power, so use the Config Save
link on the navigation panel to save your changes to the non-volatile memory
when you are done configuring.
Click New to set the screen to configure a new entry.
Click Cancel to start configuring this section of the screen again.
Enter the ID of the VLAN you want to add to the domain.
Click Apply to add the VLAN to the domain. It then appears in the table below.
Clicking Add saves your changes to the MSC's volatile memory. The MSC loses
these changes if it is turned off or loses power, so use the Config Save link on
the navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Chapter 11 Subscriber Port Setup Screens
Chapter 17 on page 531. The
265