This command enables limiting the number of IGMP control messages allowed to flow
through the specified slot and port.
The following example enables limiting of the number of IGMP control messages on port
number 2 on the line card in slot 5.
ras> multicast igmpmsgcount enable 5-2
30.10.3 multicast igmpmsgcount set Command
Syntax:
multicast igmpmsgcount set <slot-port><count>
This command sets the number of IGMP control messages allowed to flow through the
specified slot and port.
The following example sets the number of IGMP control messages to 10 on port number 2 on
the line card in slot 5.
ras> multicast igmpmsgcount set 5-2 10
30.10.4 multicast igmpmsgcount show Command
Syntax:
multicast igmpmsgcount show <slot>|<slot-port>
This command displays IGMP control message statistics for the specified slot and/or port.
The following example displays the number of IGMP control messages permitted per second
on the line card in slot 5.
ras> multicast igmpmsgcount show 5
port
enable count
----- ------ -----
5- 1
V
5- 2
V
5- 3
-
5- 4
-
30.11 multicast mvlan Commands
Use these commands to configure VLAN multicast settings and set multicast port members.
Multicast VLAN allows one single multicast VLAN to be shared among different subscriber
VLANs on the network. This improves bandwidth utilization by reducing multicast traffic in
the subscriber VLANs and simplifies multicast group management.
MSC1000G/1024G/1224G Series User's Guide
10
10
8
8
Chapter 30 multicast Commands
681