Table of Contents
Advertisement
Chapter 15 Switch Screens
Table 263 Switch > OAM (continued)
LABEL
Copy
ID
State
Card Type
Up Time
Firmware
506
DESCRIPTION
Do the following to copy settings from one Ethernet port to another Ethernet port or
ports.
1. Use the Select column to choose an Ethernet port from which you want to copy
settings.
2. Click Copy to open the following screen.
Figure 355 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the ports on the line card to which you want to copy the
settings. Click Select All to mark all of the port check boxes or click Select None
to clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this
screen. Click Cancel to close the screen without saving changes.
This is the slot number of a line card. Click the index number of an active line card to
display a screen that lists whether loopback testing is enabled or disabled for each of
the line card's ports.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be
due to the card starting, a firmware upgrade in progress or a malfunction. See
39.7 on page 974
for what to do if the line card stays stuck in the inactive state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was
started.
This field displays the current firmware version installed on the line card.
MSC1000G/1024G/1224G Series User's Guide
Section
Advertisement
Table of Contents
Troubleshooting
