ZyXEL Communications MSC1024G Series User Manual page 694

Chapter 31 port Commands
Table 325 port Commands (continued)
COMMAND
vlan
name <slot-port>
<name>
paepvc delete
set
show
pots impedance
pots gain
ppvc delete
member
694
<slot-port-vpi/
vci> <vid>
<registration>
tag
< >
<slot-port-vpi/
vci>
<slot-port-vpi/
vci> <profile>
<mux> <pvid>
<priority> [acname
<acname>]
[srvcname
<srvcname>]
[hellotime
<hellotime>]
<slot>|<slot-
port>|<slot-port-
vpi/vci>
<slot-port>
<impedance>
<slot-port> <tx-
gain> <rx-gain>
<slot-port-vpi/
vci>
delete <slot-port-
vpi/vci> <vpi/vci>
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Sets the VLAN attributes of a PVC.
Sets a name for a subscriber port.
Removes a PAE PVC (PPPoA-to-PPPoE
PVC).
Configures a PVC for PAE translation.
acname: The host name of the access
concentrator.
srvcname: A descriptive name for the
service that uses this PVC.
hellotime: The timeout (0~600
seconds) for the PPPoE session.
Note: Make sure the VID is not
already used for MVLAN or
TLS PVC.
Displays the PAE PVC settings for the
specified port and/or slot.
Sets the impedance level on the specified
subscriber port.
impedance: 200ohm_680ohm_100nf,
220ohm_680ohm_100nf,
220ohm_820ohm_115nf,
220ohm_820ohm_120nf,
270ohm_750ohm_150nf,
300ohm_1000ohm_220nf,
370ohm_620ohm_310nf, 600ohm,
600ohm_1000nf, 900ohm,
900ohm_2160nf and DEFVAL
Note: DEFVAL impedance is set
at the impedance of the
country defined in the
countrycode command.
Sets the amount of gain (increase in
volume) to apply to the signal the
subscriber transmits (tx) or the signal the
subscriber receives (rx). (-200~200 in 0.1
dB).
A negative value decreases the volume.
Removes a priority-based PVC.
Removes a PVC channel from a PVC
group.
P
M
M
M
M
L
M
M
M