Pppoe Screen - ZyXEL Communications MSC1024G Series User Manual

Chapter 5 Access Control List Screens
Figure 67 DSCP > Port: Slot
The following table describes the labels in this screen.
Table 35 DSCP > Port: Slot
LABEL
UP
Copy
Port
Enable
Select

5.18 PPPoE Screen

Use the ACL > PPPoE screen to configure PPPoE line information setting by VLAN. The
switch adds the line information to PPPoE packets for identification and security.
130
DESCRIPTION
Click UP to go back to the previous screen.
Do the following to copy settings from one port to another port or ports.
1. Select the Select radio button of the port from which you want to copy settings
2. Click Copy.
3. Select to which line card you want to copy the settings.
4. Select to which ports on the line card you want to copy the settings. Use Select
All to select every port. Use Select None to clear all of the check boxes.
5. Click Apply to paste the settings.
This field displays the number of the DSL port.
This field displays whether or not mapping of DSCP code points to IEEE 802.1p
priorities for traffic the Device sends out through this port is turned on.
the number of a VLAN to which you do not want to send broadcast traffic (through
the specified port).
Select the radio button of the port from which you want to copy settings.
MSC1000G/1024G/1224G Series User's Guide