Vdsl Profile Setup - ZyXEL Communications MSC1024G Series User Manual

Table 140 ADSL Profile (continued)
LABEL
Down-shift
Noise Margin
(0.1 dB)
Apply
New
Cancel
The bottom part of the screen lists the configured profiles.
Index
Name
Latency Mode
Down/Up RA
Mode
Down/Up Max
Rate (kbps)
Modify
Delete

13.5 VDSL Profile Setup

Click Profile > VDSL in the navigation panel to open the following screen. Use this screen to
configure VDSL profiles for VLCs that follow the VDSL MIB as defined in ADSL Extension
Line MIB (RFC 3440). Later you can use the VDSL profiles to configure VDSL ports in the
VDSL Port Setup screens.
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
The downstream down shift signal to noise margin (measured in tenths of a
decibel). When the channel's signal to noise margin goes below this number, the
device shifts to a lower transfer rate. Configure the downstream down shift signal
to noise margin to be less than or equal to the target downstream signal to noise
margin and greater than or equal to the minimum downstream signal to noise
margin.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
While you are modifying a profile, you can click New to start configuring a fresh
profile without saving your changes.
Click Cancel to start configuring the screen again.
This is the port profile index number.
These are the names of individual profiles. The DEFVAL profile always exists and
all of the DSL ports have it assigned to them by default.
This is the ADSL latency mode (fast or interleave) for the ports that belong to this
profile.
These are the downstream and upstream rate adaptation settings for the ports that
belong to this profile.
These are the maximum downstream and upstream transfer rates for the ports
that belong to this profile.
Select a profile's Select radio button and click Modify to edit the profile.
Select a profile's Select radio button and click Delete to remove the profile.
Chapter 13 Profile Screens
329