Table of Contents
Advertisement
Table 115 Port > G.bond
LABEL
Member Port
New
Delete
Cancel
Apply
ID
State
Card Type
Up Time
Firmware
11.22 The VoIP SIP Port Setup Screen
Use this screen to manage and configure the VoIP settings of each port on your SIP (Session
Initiation Protocol) enabled line card(s). Click Port > VoIP SIP. The following screen
displays.
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
This link displays the ports configured to a group. If no ports have been
configured to a group, the link will show "None".
Click this link to display a popup screen. Select the port(s) in this screen to
allocate them to the DSL line group.
Ports may not be shared between line groups. For example, if port 1 belongs to
"Group1", it may not belong to "Group2".
•
G. bond on ADSL lines only supports pairs of ports (1, 2), (3, 4) and so on up
to (47, 48).
•
G. bond on SHDSL lines supports multiple ports.
Click Apply to save your settings.
Click New to configure a new group.
Click Delete to delete the group entry displayed.
Click Cancel to start configuring this section of the screen again.
Click Apply to create the G.bond entry.
Clicking Apply saves your changes to the MSC's volatile memory. The MSC
loses these changes if it is turned off or loses power, so use the Config Save
link on the navigation panel to save your changes to the non-volatile memory
when you are done configuring.
This field displays the number of the selected line card slot.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This
could be due to the card starting, a firmware upgrade in progress or a
malfunction. See
Chapter 39 on page 969
stuck in the inactive state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it
was started.
This field displays the current firmware version installed on the line card.
Chapter 11 Subscriber Port Setup Screens
for what to do if the line card stays
279
Advertisement
Table of Contents
Troubleshooting
