Chapter 31 port Commands
This command displays upstream rate limiting settings on a PVC. The following example
shows the PVC rate settings on port 1 of the line card in slot 5.
ras> port pvc usratelimit show 5-1
pvc
-------------- ---- --------------
5-1-0/33
31.27.10 port pvc vlan Command
Syntax:
port pvc vlan <slot-port-vpi/vci> <vid> <registration> <tag>
where
<slot-port-vpi/
vci>
<vid>
<registration>
<tag>
This command adds a PVC to a VLAN or removes a PVC from a VLAN. It also sets whether
the PVC sends frames with or without a VLAN tag.
The following example adds the PVC on DSL port 5 on the line card in slot 7 with VPI 8 and
VCI 35 to VLAN 23.
ras> port pvc vlan 7-5-8/35 23 join untag
31.28 port shdsl Commands
Use the
port shdsl
31.28.1 port shdsl alarmprof Command
Syntax:
port shdsl alarmprof <slot-port> span|stuc|stur|* <alarmprofile>
738
en
rate
-
1000(kbps)
=
The slot and port(s) and VPI/VCI of the PVC.
=
The VLAN ID. Valid parameter range = [1 – 4094].
This must be the VLAN ID of a VLAN that is already configured. The
ports specified in this command must also be set to the fixed status
in the VLAN.
=
The VLAN membership setting.
join
: Adds the PVC to the VLAN.
: Removes the PVC from the VLAN.
leave
=
The VLAN tagging setting.
tag
: The specified port(s) accept only incoming Ethernet frames
that have a VLAN tag.
untag
: The specified port(s) accept only incoming Ethernet frames
that do not have a VLAN tag.
commands to configure the subscriber SHDSL ports.
MSC1000G/1024G/1224G Series User's Guide