Chapter 37 voip Commands
37.4 voip h248 Commands
Use these commands to manage the VoIP line cards.
37.4.1 voip h248 interface bhca command
Syntax:
voip h248 interface bhca <id> <peak> <average>
where
peak
average
Use this command to set the maximum number of Busy Hour Call Attempts (BHCA) allowed
per second (peak) and per hour (average).
The following example configures H.248 interface 1 to allow up to 20 call attempts per second
and 10,000 call attempts per hour.
ras> voip h248 interface bhca 1 20 10000
37.4.2 voip h248 interface group command
Syntax:
voip h248 interface group <id> <primary> <secondary>
where
primary
secondary
Use this command to set the slot numbers of the interface's active and backup signaling cards.
The following example configures H.248 interface 1 to use a VOP in slot 3 as the primary
(active) signaling card and a VOP in slot 6 as the secondary (backup) signaling card.
ras> voip h248 interface group 1 3 6
37.4.3 voip h248 interface ip command
Syntax:
voip h248 interface ip <id> <ip-address>[/<mask>] <vid>
Use this command to set the H.248 interface's IP address, subnet mask, and VLAN ID. The
active signaling card uses this IP address to communicate with the Media Gateway Controllers
(MGC).
944
The maximum number of call attempts per second (0~30).
The maximum number of call attempts for an hour (0~60000).
The number of the slot containing the active signaling card.
The number of the slot containing the backup signaling card.
MSC1000G/1024G/1224G Series User's Guide