Show Linestat Command; Show Mac Command - ZyXEL Communications MSC1024G Series User Manual

Chapter 33 show Commands
Table 339 Line Rate Information (continued)
LABEL
actual rate
attainable
rate
noise margin
attenuation

33.3.19 show linestat Command

Syntax:
show linestat <slot-port>
This command displays a port's link status.
The first example displays the link status for port 5 on the ADSL line card in slot 7.
ras> show linestat 7-5
port link
---- ----------- ------------- ------------- -------------- --------------
5 up
The second example displays the link status for port 8 on the VoIP line card in slot 4.
ras> show linestat 4-8
port linestate
---- ----------- ------------
4-8 off hook

33.3.20 show mac Command

Syntax:
show mac [enet1|enet2|t1|<mac>|<slot>|<slot-port>|{vid <vid1>[-<vid2>]
This command displays the IEEE 802.1d MAC address forwarding table. The following
example displays the IEEE 802.1d MAC address forwarding table on Ethernet port 1.
ras> show mac enet1
vid mac(total:
---- ----------------- -----
1 00:00:04:a0:00:31 enet1
1 00:00:1c:d4:1c:f6 enet1
1 00:00:e2:82:7d:90 enet1
1 00:02:3f:6c:6f:0a enet1
846
DESCRIPTION
These are the data transfer rates (in Kbps) at which the port is receiving and
sending data.
These are the highest theoretically possible transfer rates (in Kbps) at which the
port could receive and send data.
These are the DSL line's noise margins. Measured in decibels (dB).
These are the reductions in amplitude of the DSL signals. Measured in decibels
(dB).
usPayLoadRate dsPayLoadRate
(kpbs) (kpbs)
999
phonestate
conversation caller
52) port
protocol
23995 adsl2plus
MSC1000G/1024G/1224G Series User's Guide
up time
4h58m