ZyXEL Communications MSC1024G Series User Manual page 909

Table 348 sys Commands (continued)
COMMAND
hostname
location
show
monitor set
show
multilogin disable
enable
show
reboot
[show|sec|ca
ncel]
server enable
disable
port
show
snmp getcommunity
setcommunity
show
trapcommunit
y
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Sets the system name.
<hostname>
Sets the geographic location of the
<location>
system.
Displays general system and system
information.
Sets hardware monitor alarm thresholds.
<slot>
<volt|temp|fan|cpu
volt: Voltage
|mem|pbuf> <index>
index: 1~5 (the number of voltage
<high-limit> <low- sensors varies by card)
limit>
temp: temperature
index: 1~3
fan: for system FAN,
index: 1~6 (the number of fans varies by
chassis)
cpu: CPU
index: 1
mem: Memory
index: 1
pbuf: Packet buffer for transmission and
receiving.
index: 1
Displays the hardware monitor threshold
<slot>
settings of a slot.
Turns off multiple concurrent logins.
Turns on multiple concurrent logins.
Displays the multiple login setting.
Restarts the system.
show: Displays the reboot schedule.
sec: Sets the number of seconds
(1~2147483647) before the system
reboots. If there is no time specified, the
system reboots immediately.
cancel: Aborts the scheduled system
rebooting.
Turns on service access to the switch.
telnet|ssh|ftp|web
|icmp|snmp
Turns off service access to the switch.
telnet|ssh|ftp|web
|icmp|snmp
Sets a port for a service.
telnet|ftp|web|snm
p|ssh <port>
Displays service access control settings.
Sets the SNMP GetRequest community.
<community>
Sets the SNMP SetRequest community.
<community>
Displays SNMP settings.
Sets the SNMP Trap community.
<community>
Chapter 35 sys Commands
P
M
M
L
M
L
M
M
L
H
M
M
M
M
L
M
M
L
M
909