Mvlan Port Setting Screen - ZyXEL Communications MSC1024G Series User Manual

Chapter 10 Multicast Screens
Table 73 MVLAN Setup (continued)
LABEL
Cardname
Port
Apply
New
Cancel
Modify
Delete
VID
Name

10.7 MVLAN Port Setting Screen

Click Multicast > MVLAN in the navigation panel to display the MVLAN configuration
screen. When creating or editing a MVLAN, click a line card's index link to open the
following screen where you can edit the membership settings of the card's ports.
Figure 121 MVLAN Port Setting
206
DESCRIPTION
This field displays the model of the installed card.
This section shows each port's membership in the MVLAN.
F: The port is a permanent member of the MVLAN.
X: The port is prohibited from joining the MVLAN.
-: MVLAN does not apply to the MSC's Gigabit Ethernet ports.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click New to start configuring the screen again.
Click Cancel to start configuring the screen again.
Select a MVLAN's Select radio button and click Modify to edit the MVLAN.
Select a MVLAN's Select radio button and click Delete to remove the MVLAN.
This field displays the ID number of the MVLAN. Click it to edit the multicast group
that the MVLAN uses.
This field displays the descriptive name for this MVLAN.
MSC1000G/1024G/1224G Series User's Guide