Table of Contents
Advertisement
Chapter 5 Access Control List Screens
Figure 66 ACL > DSCP > Port
The following table describes the labels in this screen.
Table 34 ACL > DSCP > Port
LABEL
Slot
Port
Load
Enable
Apply
Cancel
128
DESCRIPTION
Use the drop-down list boxes to select a line card and port.
Click Load to display the port's current settings.
Select this to have the Device map DSCP code points to IEEE 802.1p priorities for
traffic the Device sends out through this port.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config
Save on the navigation panel and then the Save button to save your changes to the
non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
MSC1000G/1024G/1224G Series User's Guide
Advertisement
Table of Contents
Troubleshooting
