The Profile Voip Dsp Screen - ZyXEL Communications MSC1024G Series User Manual

Table 162 Profile > VoIP SIP CALLSVC Screen
LABEL
Apply
New
Cancel
Index
Name
Select
Modify
Delete

13.21 The Profile VoIP DSP Screen

Use this screen to configure the VOP's Digital Signal Processing (DSP) settings. You can then
select a set of DSP information (known as a profile) and assign it to a port in the Port > VoIP
SIP or Port > VoIP H248 screen.
Click Profile > VoIP DSP. The following screen displays.
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Click Apply to save the changes in this screen to the system's volatile
memory. The system loses these changes if it is turned off or loses power,
so use the Config Save on the navigation panel and then the Save button
to save your changes to the non-volatile memory when you are done
configuring.
While you are modifying a profile, you can click New to start configuring a
fresh profile without saving your changes.
Click Cancel to start configuring the screen again.
This is an incremental number indicating the order in which the call
service profiles were created.
This is the name of the call service profile.
Select the call service profile you wish to modify or delete.
Select a call service profile and click this in order to edit its configuration.
Select a call service profile and click this to delete the profile. Once
deleted, information cannot be retrieved.
Chapter 13 Profile Screens
369