ZyXEL Communications MSC1024G Series User Manual page 869

Table 347 switch Commands (continued)
COMMAND
dot3ad
dscp
MSC1000G/1024G/1224G Series User's Guide
set <md-name> <ma-
name> <mep-id>
<giga-port>|<slot-
port> <direction>
<priority> [cci
<cci-enabled>]
[alm <alarm-time>]
[rst <reset-
time>] [mac <mac>]
mip delete <md-name>
<ma-name> <giga-
port>|<slot-port>
set <md-name> <ma-
name> <giga-
port>|<sid> <mac>
show [<md-name> <ma-
name>
aggport <portlist>
t1|t2|t3|t4|none
disable [t1|t2|t3|t4]
enable [t1|t2|t3|t4]
[lacp]
lacp priority
<priority>
show
timeout short|long
show
show
disable
Chapter 34 switch Commands
DESCRIPTION
Sets an endpoint in the association.
direction: Choose up|down. This is the
active SAP direction, up means CFM
PDUs are sent towards relay entity and
then forwarded to other bridge ports, down
means CFM PDUs are sent out the bridge
port to network
priority: the priority carried in those
CFM PDUs sent out from this endpoint
cci-enabled: indicate whether to issue
CCM or not, default 0
0: disabled
1: enabled
alarm-time: The time before an alarm is
issued, default 2.5 s, range is 2.5~10 s.
reset-time: The time before an alarm
state is reset, default 10 s, range is 2.5~10
s.
Note: Before using this command,
you must add the MEP ID in
the legal MEP list of the MA
using switch cfm ma
meplist set command.
Deletes a maintenance association
intermediate point (MIP).
Sets a MIP.
Displays MDs, a detailed MD or a detailed
MA configuration.
Creates a link aggregation trunk groups.
Turns off link aggregation on the specified
trunk group.
Turns on link aggregation on the specified
trunk group. lacp turns on LACP
protocol.
Sets the LACP system priority (0~65535).
Displays LACP settings.
Sets the time interval between exchanging
LACP packets.
Displays the link aggregation state.
Displays DSCP-IEEE 802.1p mappings on
this device.
Deactivates DSCP-IEEE 802.1p mappings
on this device.
P
M
M
M
L
M
M
M
M
L
M
L
L
M
869