Voip H248 Command Examples; Single Vop Card Voip H248 Command Example - ZyXEL Communications MSC1024G Series User Manual

Chapter 37 voip Commands
Here is an example.
ras> voip h248 show 3
slot
opmode
pbit
dscp
master ip1 : 0.0.0.0
master ip2 : 0.0.0.0

37.5 voip h248 Command Examples

Here are some examples of using commands to configure H.248.

37.6 Single VOP Card voip h248 Command Example

Here is an example of configuring the IES to use a single VOP card in slot 3 as both the
signaling card and a media card.
ras> profile voip h248 set MEGACO 172.16.19.24
ras> voip ip set 3 192.168.3.174/24 2
ras> voip h248 opmode 3 sc
ras> voip h248 master 3 192.168.3.174 0.0.0.0
ras> voip h248 interface ip 1 172.16.19.200/24 1
ras> voip h248 interface slave 1 1 192.168.3.174
ras> voip h248 interface mg set 1 MG1 MEGACO
ras> voip h248 interface mg enable 1
ras> voip h248 interface group 1 3 0
ras> port h248 termination 3-1~24
ras> port enable 3-1~24
Here is what each line in the example configures:
ras> profile voip h248 set MEGACO 172.16.19.24
Creates an H.248 profile named MEGACO for an Media Gateway Controller (MGC) at IP
address 172.16.19.24.
ras> voip ip set 3 192.168.3.174/24 2
Sets the VOP card in slot 3 to use IP address 192.168.3.174, subnet mask 255.255.255.0,
and VLAN ID 2. These settings are for the internal communications between the signaling
card and media card.
ras> voip h248 opmode 3 sc
Sets the VOP card in slot 3 to function as a signaling card.
ras> voip h248 master 3 192.168.3.174 0.0.0.0
948
: 3
: mc
: 7
: 48
A301 1
MSC1000G/1024G/1224G Series User's Guide