Chapter 21 acl Commands
21.5.4 acl dhcpsnoop pool set Command
Syntax:
acl dhcpsnoop pool set <slot-port> <ip-address>
This command adds a static IP address to the DHCP snooping table on a port.
The following example adds two static IP addresses (
the DHCP snooping table on port 10 of the line card in slot 2.
ras> acl dhcpsnoop pool set 2-10 192.168.1.10
ras> acl dhcpsnoop pool set 2-10 192.168.1.11
ras> acl dhcpsnoop show 2-10
port enable static ip pool
----- ------ -----------------------------------------------
2-10
ras>
21.5.5 acl dhcpsnoop pool delete Command
Syntax:
acl dhcpsnoop pool delete <slot-port> <ip-address>
This command removes a static IP address from the DHCP snooping table of a port on the
specified line card. The following example removes the static IP address of 192.168.1.11 from
the port 10 on the line card in slot 2.
ras> acl dhcpsnoop pool delete 2-10 192.168.1.11
ras> acl dhcpsnoop show 2-10
port enable static ip pool
----- ------ -----------------------------------------------
2-10
ras>
21.5.6 acl dhcpsnoop show Command
Syntax:
acl dhcpsnoop show <slot>|<slot-port>
Use this command to display the current static DHCP snooping settings of the port(s) on the
line card. The following example displays the settings of port 10 on the line card in slot 2.
ras> acl dhcpsnoop show 2-10
port enable static ip pool
----- ------ -----------------------------------------------
2-10
ras>
21.6 acl dot1x Commands
Use these commands to configure the IEEE 802.1x authentication feature.
596
-
192.168.1.10
-
192.168.1.10
-
192.168.1.10
192.168.1.10
192.168.1.11
192.168.1.11
MSC1000G/1024G/1224G Series User's Guide
and
) to
192.168.1.11