The Voip H248 Screen - ZyXEL Communications MSC1024G Series User Manual

Table 296 The VoIP > Number Plan Screen
LABEL
Modify
Delete

18.9 The VoIP H248 Screen

Click VoIP > VoIP H248 to open the screen below. Use this screen to configure settings
specific to the system's individual H.248 VoIP cards. To configure other H.248 settings, assign
H.248 profiles to a VoIP card's individual ports in the Port > VoIP H248 screen.
Figure 387 The VoIP > H248 Screen
The following table describes the labels in this screen.
Table 297 The VoIP > H248 Screen
LABEL
Slot
Operational Mode
Master IP 1
Master IP 2
802.1P 802.1p
Priority
DSCP
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Select a number plan table and click this in order to edit its configuration.
Select a number plan table and click this to delete the profile. Once deleted,
information cannot be retrieved.
DESCRIPTION
Select the slot number of the line card you want to configure.
Set this VoIP card to act as a media card or a signaling card.
Enter the IP address of the signaling card. This can be the IP address of either
an active or a standby signaling card. This IP address is for communicating with
the media cards and should be in a different subnet from the H.248 interface's IP
address.
If there is a standby signaling card, enter the IP address of the secondary
signaling card here.
Specify the IEEE 802.1p priority (0~7) to use for this VoIP card's traffic. The
system changes the priority in IGMP protocol messages snooped on a member
subscriber port to the priority you specify here.
Enter the DSCP service level to use for this VoIP card's traffic.
Chapter 18 VoIP
563