Chapter 30 multicast Commands
After using this command, if the device receives a join report and the total multicast traffic at
that moment is over 1000 kbps, the device ignores the join report.
30.3.4 multicast bandwidth port show Command
Syntax:
multicast bandwidth port show <slot|slot-port>
This command displays the multicast bandwidth setting on the specified port. The following
example shows the multicast bandwidth setting for port 1 on the line card in slot 2.
ras> multicast bandwidth port show 2-1
port
enable
------ ------ -----------
2- 1
30.4 multicast Group MAC Address Commands
Use these commands to allow incoming frames based on multicast MAC address(es) that you
specify. Use this feature to pass allowed layer 2 multicast packets through the IES.
30.4.1 multicast groupmacaddr del Command
Syntax:
multicast groupmacaddr del <vid> <group-mac-addr>
where
<group-mac-
addr>
This command removes a static multicast group entry by MAC address. The following
example removes multicast MAC address 01:01:5E:00:00:05 from VID 2.
ras> multicast groupmacaddr del 2 01:01:5E:00:00:05 9-2 fix
30.4.2 multicast groupmacaddr set Command
Syntax:
multicast groupmacaddr set <vid> <group-mac-addr> <giga-port>|<slot-port>
fix|forbid
where
<group-mac-
addr>
674
bandwidth
V
1024
The static multicast MAC address.
=
=
The static multicast MAC address.
MSC1000G/1024G/1224G Series User's Guide