ZyXEL Communications MSC1024G Series User Manual page 120

Chapter 5 Access Control List Screens
Figure 59 802.1X PNAC: Port Setup
The following table describes the labels in this screen.
Table 27 802.1X PNAC: Port Setup
LABEL
Slot
Port
Load
Enable
Control
Reauthentication Specify if a subscriber has to periodically re-enter his or her username and
Reauthentication
Period(s)
Apply
Cancel
120
DESCRIPTION
Use the drop-down list boxes to select an DSL port on a line card for which you
wish to configure IEEE 802.1x authentication.
Click Load to display the port's current settings.
Select this check box to turn on IEEE 802.1x authentication on the system.
Select AUTO to authenticate all subscribers before they can access the network
through this port.
Select FORCE AUTHORIZED to allow all connected users to access the network
through this port without authentication.
Select FORCE UNAUTHORIZED to deny all subscribers access to the network
through this port.
password to stay connected to the port.
Specify how often a client has to re-enter his or her username and password to stay
connected to the port.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config
Save on the navigation panel and then the Save button to save your changes to the
non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
MSC1000G/1024G/1224G Series User's Guide