ZyXEL Communications MSC1024G Series User Manual page 140

Chapter 5 Access Control List Screens
Table 40 ACL > Upstream Storm (continued)
LABEL
Broadcast
Multicast
Unknown Unicast
Apply
Cancel
Copy
Apply
Cancel
ID
State
Card Type
140
DESCRIPTION
Select Disable to not limit the number of broadcast packets the interface will
accept per second.
Type how many broadcast packets the interface should accept per second.
Select Disable to not limit the number of multicast packets the interface will
accept per second.
Type how many multicast packets the interface should accept per second.
Select Disable to not limit the number of unknown unicast packets the interface
will accept per second. Unknown unicast packets are also known as destination
lookup failure (DLF) packets.
Type how many unknown unicast packets the interface should accept per second.
Click Apply to save the changes in this part of the screen to the system's volatile
memory. The system loses these changes if it is turned off or loses power, so use
the Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Do the following to copy the settings you configure above to another port or ports.
1. Click Copy.
2. Select the line card to which you want to copy the settings.
3. Select to which ports on the line card you want to copy the settings. Use
Select All to select every port. Use Select None to clear all of the check
boxes.
4. Click Apply to paste the settings.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This is the slot number of a line card. Click the index number of an active line card
to display the Upstream Storm- Slot screen where you can view and copy
settings from one port to another port or ports on the selected line card.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could
be due to the card starting, a firmware upgrade in progress or a malfunction. See
Section 39.7 on page 974 for what to do if the line card stays stuck in the inactive
state.
This field displays the type of a line card.
MSC1000G/1024G/1224G Series User's Guide