Chapter 31 port Commands
31.27.3 port pvc mvlan enable Command
Syntax:
port pvc mvlan enable <slot-port-vpi/vci>
This command enables multicast VLAN on the PVC.
31.27.4 port pvc set Command
Syntax:
port pvc set <slot-port-vpi/vci> <profile> <mux> <pvid> <priority>
where
<slot-port-vpi/
vci>
<profile>
<mux>
<pvid>
<priority>
This command creates or modifies a PVC setting.
The following example sets a PVC on DSL port 5 on the line card in slot 2 with VPI 8, VCI
35, the DEFVAL profile, default VID 2 and priority 3.
ras> port pvc set 2-5-8/35 DEFVAL vcmux 2 3
31.27.5 port pvc show Command
Syntax:
port pvc show <slot>|<slot-port>|<slot-port-vpi/vci> [detail]
where
<slot-port-vpi/
vci>
[detail]
This command displays the runtime configured virtual channels for the specified DSL port(s).
736
=
The slot and port(s) and VPI/VCI of the PVC.
=
The name of an ATM profile.
The type of encapsulation:
=
Set a default VID (1 to 4094) for the channel. The channel can only
=
forward frames with this VLAN ID. The system would drop any
frames received from the subscriber that are tagged with another
VLAN ID.
Each PVC must have a unique VID since the system forwards
traffic back to the subscribers based on the VLAN ID.
Set an IEEE 802.1p default priority (0 to 7) to add to incoming
=
frames without a (IEEE 802.1p) priority tag.
The slot and port(s) and VPI/VCI of the PVC.
=
Displays in depth information about the runtime configured virtual
=
channels.
MSC1000G/1024G/1224G Series User's Guide
,
llc
vcmux