34.12.12 switch port show Command
Syntax:
switch port show
This command displays the settings for the system's Gigabit Ethernet interfaces. An example
is shown next.
ras> switch port show
port
----- --------------- ---- ---- ------ ---- ---- ---- ---- ----- ---- ----
sub1 Subtend1
sub2 Subtend2
up1 Uplink1
up2 Uplink2
34.12.13 switch port speed Command
Syntax:
switch port speed <giga-port> <speed>
where
<giga-port>
<speed>
This command sets the port speed and duplex of a 1000BaseT uplink port(s).
The following example sets the speed of the uplink 1 Gigabit Ethernet interface to 1000 Mbps
and the duplex to full.
ras>
switch port speed up1 1000F
34.13 switch port vlantrunk Commands
Use these commands to turn VLAN trunking on or off for the Gigabit Ethernet interfaces.
34.13.1 switch port vlantrunk enable Command
Syntax:
switch port vlantrunk enable <giga-port>
MSC1000G/1024G/1224G Series User's Guide
name
en
mode speed
V
up
V
up
V
up
V
up
=
This represents 1000BaseT uplink ports. The port speed is fixed for
subtending ports and/or SFP slots that use a fiber-optic interface. Use
up1|up2|all i
trunking is enabled.
=
The port's speed and duplex mode.
Use
auto|1000F|100F|100H
Auto or 1000 (Mbps) or 100 (Mbps) is to match the port speed of the
WAN switch to which this port is to connect.
F is for full duplex communications or H for half duplex
communications.
Chapter 34 switch Commands
fc
pvid prio gvrp ftype
auto
-
1
0
auto
-
1
0
auto
-
1
0
auto
-
1
0
f trunking is not enabled. Use
.
vt
dscp
-
all
-
-
-
all
-
-
-
all
-
-
-
all
-
-
tup|all
if
901