Figure 106 Restart After Load Factory Defaults
9.4 Firmware Upgrade Screen
Click Maintenance > Firmware Upgrade in the navigation panel to open the following
screen. Use this screen to view your current firmware version number and upload firmware to
cards in the system. Make sure you have downloaded (and unzipped) the correct model
firmware and version to your computer before uploading to the card.
Be sure to upload the correct model firmware as uploading the wrong model
firmware may damage a card.
Figure 107 FW Upgrade
The MSC supports dual firmware images, ras-0 and ras-1. You can switch them from one to
the other by selecting the Boot Image and clicking Apply. The system doesn't reboot after it
completes a firmware upgrade.
Select the check boxes beside the card or cards to which you want to upload firmware. You
can simultaneously upload firmware to cards of the same type. You can only upload firmware
to cards that are active.
MSC1000G/1024G/1224G Series User's Guide
Chapter 9 Maintenance Screens
191