Chapter 17 VLAN Screens
3 The MSC ignores the port from which the frame came, because the MSC does not send a
frame to the port from which it came. The MSC also does not forward frames to
"forbidden" ports.
4 If after looking at the SVLAN, the MSC does not have any ports to which it will send the
frame, it won't check the port filter.
17.6 VLAN Setup Screen
Click VLAN > VLAN in the navigation panel to display the screen shown next. You can
assign the management switch card's Gigabit Ethernet interfaces to be members of a VLAN
group or prohibit an interface from joining a VLAN group in this screen. This is an IEEE
802.1Q VLAN.
Figure 369 VLAN Setup
The following table describes the labels in this screen.
Table 283 VLAN Setup
LABEL
Enable
Name
VID
Port
534
DESCRIPTION
Select this check box to turn on the VLAN group. You cannot disable a VLAN if any
PVIDs are set to use the VLAN or the VLAN is the CPU (management) VLAN.
Enter a descriptive name for this VLAN group for identification purposes.
Enter the VLAN ID (VLAN Identifier) for this static VLAN entry; the valid range is
between 1 and 4094.
This is the label of a Gigabit Ethernet interface.
MSC1000G/1024G/1224G Series User's Guide